Build Your Own Wood Shelves

7Mar/100

If you know how to build your own wooden shelves, you can transform any room in the house in a storage space more efficiently, with more viewing area. Lounge, kitchen and the bedroom to the guest room or bathroom, simple shelves wall furniture are capable of handling type of project for the inexperienced wood processing.

What you need

To make the project of floating shelves, you will need a main port empty of 18 inches, saw the table, an inch bits and gear drill with the long, wooden live, hammer, brads protection, such as goggles and ear plugs.

Make shelves

Cut a piece of port 8 inches wide. Blank ports have corrugated curly braces in the Centre, then scraper that those so far then add fit inside. The part of sand until all the smooth bumps. Therefore, stain or paint the part that you want.

Holds

To give the illusion of no support, mobile shelves are protected the wall of holds. These are bands of wood that almost the length of the tablet to practise such chiodati wall so Ray fit perfectly on them. To make the holds, you must measure the thickness of the bus stop exactly. Interior to measure the length of the port, from top to bottom, as well as the exact width. Cut-2 x 4 inch piece of wood to the interruption of the same length. And then redefine the other measurements of height.

Holds hanging

Mark slightly where you want to block the shelves with a pencil. Use a genealogical search engine to locate the peaks in the walls and then mark than light with a pencil. Pre-drill through the checkpoint and poles with a bit of an inch and then install a screw in each position until the stop blocks straight and strong.

Locks the rays

Make sure that the mobile platform fit exactly the tab, press and hold the tray until the bus stop and a dry form as doesn ' t involve glue or screws. Make adjustments depending on what is necessary. If you are certain that the adjustment is accurate, apply the glue of wood at the top of the tab, and then adjust the top shelf. Protect the shelf to stop brads nailed to the top of the plateau in the tab stop.

[answer]